The SST49LF160C flash memory device is designed to interface with host controllers (chipsets) that support a lowpin-count (LPC) interface for system firmware applications.The SST49LF160C device complies with the LPC Interface Specification. The LPC interface operates with 5 signal pins versus 32 pins of a 8-bit parallel flash memory. This frees up pins on the ASIC host controller resulting in lower ASIC costs and a reduction in overall system costs due to simplified signal routing.

   Organized as 2M x8

   Conforms to LPC Interface Specification– Support Single-Byte LPC Memory Read/WriteCycles

   Single 3.0-3.6V Read and Write Operations

   LPC Mode– 5-signal LPC bus interface for both in-systemand factory programming using programmerequipment– 33 MHz clock frequency operation– WP#/AAI and TBL# pins provide hardware Writeprotect for entire chip and/or top Boot Block– Block Locking Registers for individual block Read-Lock, Write-Lock, and Lock-Down protection– 5 GPI pins for system design flexibility– 4 ID pins for multi-chip selection– Status register for End-of-Write detection– Program-/Erase-SuspendRead or Write to other blocks duringProgram-/Erase-Suspend

   Two-cycle Command Set

   Security ID Feature– 256-bit Secure ID space- 64-bit Unique Factory Pre-programmedDevice Identifier- 192-bit User-Programmable OTP

   Superior Reliability– Endurance: 100,000 Cycles (typical)– Greater than 100 years Data Retention

   Low Power Consumption– Active Read Current: 12 mA (typical)– Standby Current: 10 μA (typical)

   Uniform 4 KByte sectors– 35 Overlay Blocks: one 16-KByte Boot Block,two 8-KByte Parameter Blocks, one 32-KbyteParameter Block, thirty-one 64-KByte MainBlocks.

   Fast Sector-Erase/Program Operation– Sector-Erase Time: 18 ms (typical)– Block-Erase Time: 18 ms (typical)– Program Time: 7 μs (typical)

   Auto Address Increment (AAI) for Rapid FactoryProgramming (High Voltage Enabled)– RY/BY# pin for End-of-Write detection– Multi-Byte Program– Chip Rewrite Time: 4 seconds (typical)

   Packages Available– 32-lead PLCC

   All non-Pb (lead-free) devices are RoHS compliant