The MCP795W11 SPI RTCC is highly integrated with memory and advanced features normally found in higher priced devices. By starting with a basic real-time clock, digital trimming was added for higher accuracy, a battery switchover for backup power, a timestamp to log power failures and three types of memory, which includes SRAM, EEPROM and a unique ID in a locked section of EEPROM that is preprogrammed with a 48-bit MAC Address that can also be ordered blank for the end user to program. By adding a watchdog timer and two programmable event detect inputs, lower power and more system robustness can be achieved by off-loading MCU functions and allowing it to sleep for longer periods of time.

Full Featured RTCC targets smart energy, communications and home appliance applications.

  Low Power Operation

  VCC Min = 1.8V

  Icc

  Low Backup Power

  VBAT Min = 1.3V

  Ibat

  Automatic Battery Switchover with Timestamp

  VCC to VBAT (VCC Lost)

  VBAT to VCC (VCC Restored)

  Dual configurable alarms with a 0.01 sec count on one alarm

  IRQ (VCC or VBAT)

  WDO (VCC)

  Clock Out frequencies: 32.768, 8.192 & 4.096 KHz and 1 Hz

  Digital Trimming Range from -255 to + 255 ppm in 1 ppm steps

  Adjusts up to 22 seconds/day

  Watchdog Timer - Dual Retriggers

  SPI Bus or EVHS digital input

  Dual Configurable Event Detects

  High speed with programmable pulse count (EVHS)

  Low speed with programmable debounce delay (EVLS)

  EEPROM has 8 Bytes/Page with Block Sector write protection

  Protect: None, 1/4, 1/2 or all of array

  Unique ID is factory programmed with MAC Address