The MIC7401 is a powerful, highly integrated, configurable, power-management IC (PMIC) featuring five synchronous buck regulators, one boost regulator, and a high-speed I2C interface with an internal EEPROM.The device offers two distinct modes of operation 'stand-by mode' and 'normal mode' intended to provide an energy-optimized solution suitable for portable handheld, and infotainment applications.In normal mode, the programmable switching converters can be configured to support a variety of features, including start-up sequencing, timing, soft-start ramp, output voltage levels, current-limit levels, and output discharge for each channel.In stand-by mode the PMIC can be configured in a low power state by either disabling an output or by changing the output voltage to a lower level. Independent exit from stand-by mode can be achieved either by I2C communication or by the external STBY pin.

The device has five synchronous buck regulators with high-speed adaptive on-time control that supports even the most challenging ultra-fast transient requirement for core supplies. One boost regulator provides a flash-memory programming supply that delivers up to 200mA of output current. The boost is equipped with an output disconnect switch that opens if a short-to-ground fault is detected.An internal EEPROM enables a single-chip solution across many platforms by allowing the designer to customize the PMIC for their design. Modifications can be made without the need to re-approve a new PMIC, saving valuable design resources and time. All switchers provide light-load efficiency with HyperLight Load? mode for buck and PFM mode for boost. An additional benefit of this proprietary architecture is very-low output ripple voltage throughout the entire load range with the use of small output capacitors. The MIC7401 is designed for use with a small inductors (down to 0.47?H for buck, 1.5?H for boost), and an output capacitor as small as 10?F for buck, enabling a total solution size of 12mm x 8.5mm and less than 1mm height on the top layer.

  Input voltage: 2.4V to 5.5V

  Five independent synchronous bucks up to 3A

  One independent non-synchronous boost 200mA

  200μA quiescent current (all regulators on)

  5μA typical shutdown current

  93% peak buck efficiency, 85% typical efficiency at 1mA

  Dual power mode: stand-by and normal mode

  I2C interface up to 3.4MHz

  I2C on-the-fly EEPROM programmability, featuring:

  Buck and boost output voltage scaling

  Power-on-Reset (PoR) threshold and delay

  Power-up sequencing/sequencing delay

  Buck and boost current limit

  Buck and boost pull-down when disabled

  Individual ON, OFF, and stand-by modes

  Soft-start and global power-good masking

  23μA buck typical quiescent current

  70μA boost typical quiescent current

  1.5% output accuracy over temperature/line/load

  2.0MHz boost switching frequency

  1.3MHz buck operation in continuous mode

  Ultra-fast buck transient response

  12mm x 8.5mm x 1.25mm solution size (Top Layer)

  Thermal-shutdown and current-limit protection

  36-pin 4.5mm ? 4.5mm ? 0.85mm FQFN package (0.4mm pitch)

  -40°C to +125°C junction temperature range